Pack includes below tools.
Ballast Spreader HO/OO
Ballast Glue Applicator HO/OO
Parallel Track Tools HO/OO (2 pcs)
Flexible Track Tool HO/OO (2 pcs)
Track Voltage Tester (N, HO, OO, S, TT)
Snap & Glue Magnetic Clamps (2 pcs)
Multi Angle "Snap & Glue" Magnetic Clamps (2 pcs)
Hold & Glue Set Squeares (2 pcs)
Powered Railer HO/OO
10 Item Items
Warning: Last items in stock!
By buying this product you can collect up to 159 loyalty points. Your cart will total 159 loyalty points that can be converted into a voucher of € 7.95.
Perfect ballast spreading is never problem again with this easy to use Ballast Spreader. Slots underneath the spreader keeps your ballast in line, spreads the ballast on track and never on rails.
Ballast Gluer is another innovative tool from Proses workshops to glue track ballast with ease and quickly..
Check not just if your track has power - but also how much!Lights illuminate for 5-9V, 9-12V and +12V.Analogue DC or DCC compatible.Works on all N, HO, OO, S, TT track systems.Shows polarity.
For all HO and OO tracks. One set includes 2 Tools. This very useful track alignment tool is designed to keep the same distance between the centers of adjacent and parallel tracks. You can adjust the distance between the mids of tracks from 30 mm to 90 mm or from 1.2 inch to 3.5 inches. With Parallel Track Tool you can lay your straight and curved tracks...
Flexible track is very useful but its tendency to straighten up makes track laying difficult unless it can be held in position. This new Flexible Track Holding Tool keeps your flexible track in the desired curve temporarily before fixing it permanently. You can even hold the track in your hands, off the baseboard, without it losing its curves! Suitable...
A set of paired magnetic set squares. Simply pull apart, place inside and outside your 90 degree corner and snap into place. The snap and glue set squares hold the two pieces of plastic in place and allow you to glue them at the right angle without further worry. After curing of the adhesive do remove easily the Snap & Glue angle magnets.
Proses hold and glue right angle holders for kit buildings and modellers. Pack contains 2 holders, simply pull apart, place inside and outside your 90 degree corner and fix the wing nuts.
A set of paired magnetic clamps with adjustable angles. Simply pull apart, place inside and outside your corners and snap into place. The snap and glue set squares hold the two pieces of plastic in place and allow you to glue them at the desired angle without further worry. After curing of the adhesive do remove easily the Snap & Glue magnetic clamps.
Another great tool to end your challenges to get your long, multi wheel locos on tracks with ease. The aluminum base is powered by the track it is placed on and lets the loco run and get on the track smoothly and properly. Both ends are open to giving access to both sides of the track. Base length: 48 cm Scale: HO/OOClick to see other railers in various...