Proses hold and glue right angle holders for kit buildings and modellers. Pack contains 2 holders, simply pull apart, place inside and outside your 90 degree corner and fix the wing nuts.

A set of paired magnetic set squares. Simply pull apart, place inside and outside your 90 degree corner and snap into place. The snap and glue set squares hold the two pieces of plastic in place and allow you to glue them at the right angle without further worry. After curing of the adhesive do remove easily the Snap...

A set of paired magnetic set squares. Simply pull apart, place inside and outside your 90 degree corner and snap into place. The snap and glue set squares hold the two pieces of plastic in place and allow you to glue them at the right angle without further worry. After curing of the adhesive do remove easily the Snap...

Specifications: Board Size: 220 X 163 mm Blades: 17-19 mm scored (snap-off, break-off) standard cutter blades. Cutting height: Up to 8 mm depending on the width and hardness of timber or profile. Cutting width: Up to 30 mm depending of the height and hardness of timber or profile. Materials to cut: Soft woods, styrene,...

Specifications: Overall size: 225 X 165 X 65m Power adapter input voltage: 100/240 V Power adapter output voltage: 18-20V DC, 3A Cutting disk size: 38mm Cutting height: 5mm Materials to cut: Model train tracks, non-ferrous soft metals. <p...

Perfect ballast spreading is never problem again with this easy to use Ballast Spreader. Slots underneath the spreader keeps your ballast in line,  spreads the ballast on track and never on rails.